Central Heating System Repair in Boise, ID

Beacon Home Services provides furnace, air conditioner, and water heater inspections in Nampa, ID. They identify issues like worn blower motors, leaking refrigerant, and corroded water heaters. They assess system age, filter installation, and safety components to recommend necessary repairs or replacements for reliable HVAC and water heating performance.

Beacon Home Services provided a quote in Meridian, ID, to replace a failed HVAC system. They also offered pricing estimates for a new water heater and water softener to the homeowner.

Beacon Home Services repaired a pinhole leak in radiant copper piping in Nampa, ID. They excised and replaced the damaged copper section, then pressure-tested the system to ensure no further leaks were present.

Beacon Home Services diagnosed a 2-ton air conditioner in Nampa, ID, that was running but not cooling due to low refrigerant from a leak. They inspected the paired 60,000 BTU furnace, noting the blower motor needs replacement. They provided system replacement options and offered to fix a leaking exterior hose bib.

Beacon Home Services in Parma, ID diagnosed low refrigerant in an HVAC system, injected sealant, and recharged it, restoring efficient cooling and preventing future leaks during summer months.

Beacon Home Services in Emmett, ID diagnosed a furnace issue by checking the heater and thermostat. The heater was operating, and they found low batteries in the thermostat. They provide furnace inspection and thermostat battery replacement to ensure heating systems work properly.

Beacon Home Services provided AC maintenance in Boise, ID. They cleaned the condenser and evaporator coils, checked the capacitor and refrigerant levels, and replaced the home HVAC filter to ensure system readiness before summer.

Beacon Home Services in Caldwell, ID evaluated a 30-year-old HVAC system with electric heat and an oversized unit. They offered a quote for properly sized equipment and heat pump upgrade options to improve home heating efficiency.

Beacon Home Services in Nampa, ID inspected a rooftop unit and found a refrigerant leak. They provided clear repair options to address the issue and restore the unit's function.

Beacon Home Services performed spring air conditioning maintenance in Eagle, ID. They inspected the Lennox heating and cooling system, checked electrical components, cleaned condenser coils, verified refrigerant levels, and assessed the water heater. They identified a failed draft inducer gasket and a faulty thermal expansion tank, recommending repairs to prevent future issues.

Beacon Home Services repaired a Quiet Cool whole home fan in Meridian, ID. They inspected the fan motor and found it working correctly. They replaced the fan’s timer with a new OEM unit and verified the fan operated properly after installation.

Beacon Home Services repaired a first-floor HVAC system in Eagle, ID. They replaced a failed ECM blower motor in a 20-year-old ICP furnace and adjusted blower speeds for proper heating and cooling. They also inspected the home's electronic air cleaner and recommended filter replacements for routine maintenance.

Beacon Home Services in Nampa, ID provides plumbing and HVAC rough-in completion quotes for projects started but unfinished since 2005. They assess existing work and offer solutions to finish home mechanical systems efficiently.

Beacon Home Services inspected HVAC systems in Ontario, OR. They assessed current setups and provided quotes to install properly sized heat pump HVAC systems. This ensures efficient heating and cooling tailored to home needs.

Beacon Home Services assessed a Boise, ID home with a furnace having a cracked heat exchanger. They offered the homeowner multiple upgrade options and pricing to replace it with a zoned heat pump system.

Beacon Plumbing, Heating, and Mechanical Inc. removed a seized motor and installed a new inducer motor in Caldwell, ID. They completed a function test to ensure proper operation.

Beacon Home Services in Boise, ID provides emergency HVAC repairs. They diagnose issues like blower motor failure causing burning smells and AC malfunction. They replace faulty blower motors with OEM parts and ensure the system operates properly without error codes after installation.

Beacon Home Services in Meridian, ID, responded to an HVAC freezing issue from a 2022 installation. They identified a blower speed malfunction bypassing the thermostat. Parts are covered under the manufacturer warranty and will be replaced upon arrival.

Beacon Home Services inspected a 2003 HVAC system in Garden City, ID. They identified aging components and provided the buyer with detailed replacement quotes and credit options to support informed decision-making.

Beacon Home Services in Caldwell, ID removed an attic furnace, installed a 3-ton furnace, connected it to existing ductwork, and tested the system to ensure proper function.

Beacon Home Services in Caldwell, ID inspects furnaces and air conditioners. They test the furnace safety switch, fan, and burner assembly. They also clean indoor and outdoor HVAC units to maintain system performance and safety.

Beacon Home Services in Boise, ID, fixed incorrect thermostat wiring causing the heat pump to heat when the AC was on. They corrected the wiring and verified with a thermometer that the AC cools the home to the proper temperature.

Beacon Home Services inspected an aging HVAC system in Caldwell, ID. They confirmed the system was running well and provided a replacement estimate upon request. This service helps homeowners evaluate and plan for HVAC upgrades effectively.

Beacon Home Services inspected an HVAC system in Boise, ID. They fixed low-voltage wiring, corrected thermostat wiring, and cleaned the outdoor condenser coil. These repairs improved system communication, airflow, and efficiency. Routine maintenance and quality air filters are recommended to maintain performance.

Beacon Home Services in Meridian, ID inspects furnaces to identify heating delays. They check heat cycles and system function to ensure proper operation. They advise customers to replace filters every three months to maintain furnace efficiency and optimal heating performance.

Beacon Home Services inspected an HVAC system in Boise, ID, correcting loose wiring and low-voltage issues. They replaced the faulty run capacitor for the draft inducer motor, restoring proper system function without needing to replace the zone control board. The HVAC now operates reliably.

Beacon Home Services in Caldwell, ID charges and tests heat pumps to ensure proper operation. They inspect the system and recharge the refrigerant when necessary. This service helps maintain heat pump efficiency and performance.

Beacon Home Services diagnosed a no-heat issue in a Caldwell, ID attic furnace. They found a faulty control board showing an open limit error. The team replaced the control board and tested the furnace to ensure proper function and heat restoration.

Beacon Home Services in Nampa, ID inspected a heating and cooling system, found a minor refrigerant leak near the indoor coil, and recommended repairing it to maintain efficiency. They cleaned outdoor unit coils and advised replacing corroded water heater fittings with brass to prevent leaks.

Beacon Home Services replaced unsafe furnace wiring with a dedicated 30-amp circuit and moved the air conditioning disconnect to meet NEC clearance standards. They rewired the air conditioning unit during this safety upgrade in Caldwell, ID.

Beacon Home Services responded to a no-heat issue in Meridian, ID. They found a contractor-caused short that damaged the heat strip assembly. Beacon will provide a bid to replace the heat strip and test the unit after replacement to ensure proper function.

Beacon Home Services reinstalled the HVAC system during a whole home remodel in Caldwell, ID. They installed new ductwork and refrigeration lines, recharged the system, and performed testing to ensure proper function.

Beacon Home Services in Nampa, ID diagnosed and repaired loose wires on a heater control board causing master bedroom heating issues. They also replaced the large pre-filter on the whole house water filtration system to maintain water quality.

Beacon Home Services in Caldwell, ID repaired the HVAC system by restoring breaker power, replacing the blower motor capacitor, installing a new 16x20x1 air filter, cleaning the furnace flame sensor, correcting the AC drain line, replacing the AC contactor switch, and tightening electrical connections to ensure proper operation.

Beacon Home Services repaired a Combi boiler in Nampa, ID. The unit provides hot water and hydronic heating. They restored the boiler's operation to ensure consistent hot water supply.

Beacon Home Services in Caldwell, ID, removes old compressors, reclaims refrigerant, installs new compressors, and recharges HVAC systems. They handle compressor replacement and refrigerant management to restore system operation efficiently.

Beacon Home Services in Nampa, ID inspected a non-working furnace and found a failed inducer fan causing the high limit to fail. The furnace, installed in May 2005, is 21 years old. They provide diagnostic and repair services for older heating systems in the area.

Beacon Home Services inspected crawlspace ductwork in Caldwell, ID, finding intact ducts with buildup and unsealed return ducts allowing crawlspace air into the system. They identified a leaking furnace flue, a failed thermal expansion tank, and recommended duct sealing, cleaning, flue repair, water heater servicing, and indoor air quality upgrades.

Beacon Home Services in Star, ID, repaired a furnace fuse damaged during a thermostat installation. They replaced the fuse and tested the system to restore heating function.

Beacon Home Services replaced a 20-year-old 5-ton geothermal heat pump system in Garden Valley, ID. They fixed low voltage and zone controller failures, installed a new zoning system with a bypass damper, and repaired and sealed ductwork to improve efficiency. The geothermal unit was rebuilt to client specifications.

Beacon Home Services inspected a ceiling leak in a furnace closet and standing water in a crawlspace vapor barrier in Caldwell, ID. They found a deteriorated roof jackboot causing water intrusion and environmental moisture from poor exterior grading and drainage. No active plumbing leaks were detected.

Service Summary HVAC Maintenance & Certified Home Inspection Beacon HVAC Services came out today to perform HVAC maintenance and assist with certifying the home. We serviced a Goodman furnace (96% efficient, 60,000 BTU, single-stage) and a Goodman 3-ton air conditioning system, both installed in 2024. We inspected both the furnace and air conditioning system. The furnace is operating safely at this time. During maintenance, the burners were cleaned, and it was noted that the gas pressure should be adjusted to ensure proper operation and efficiency at our elevation. The air conditioning system was also evaluated. The outdoor condenser coil has buildup due to its location near a dryer vent. We recommend rinsing the coil periodically throughout the summer to maintain proper heat rejection and system efficiency. While checking refrigerant levels, we found the system to be overcharged. This condition can cause the system to run inefficiently and place unnecessary stress on motors and electrical components. Correcting the refrigerant charge will help restore proper performance and efficiency. a full plumbing maintenance inspection as part of the customers membership plan, ensuring the home is safe and meets Certified Home standards. During todays visit, we completed a comprehensive inspection of the homes plumbing system, including the water heater and gas fireplace. Both systems were checked for safe operation and proper performance. No carbon monoxide was detected in the home. The home is equipped with carbon monoxide detectors, and no carbon monoxide was detected at the time of inspection. All smoke detectors are less than 10 years old and functioning properly. The homeowner shared concerns about uneven temperatures, specifically the upstairs being too hot or too cold. The current thermostat is located downstairs, which can contribute to this issue. We recommend upgrading to an Ecobee smart thermostat with a remote temperature sensor placed upstairs to help improve comfort and temperature balance. Due to the design and layout of the existing ductwork, achieving consistent temperature balance throughout the home may be limited without more extensive system modifications or upgrades

Beacon Home Services performed air conditioning maintenance and system inspection in Meridian, ID. They cleaned AC coils, checked refrigerant levels, and restored the water heater’s thermal expansion tank pressure. They also identified rust and ash inside the furnace cabinet, recommending timely repair to prevent damage.

Beacon Home Services performed air conditioner maintenance in Nampa, ID. They cleaned debris from the outdoor condenser coils, tested the HVAC system’s heating and cooling functions, and corrected wiring and blower speed settings. The technician also addressed a weak capacitor and inspected furnace components to ensure proper operation.

Beacon Home Services in Wilder, ID inspects and maintains heat pumps and electric furnaces. They perform full system tune-ups, clean outdoor condenser coils, and check air filters to ensure efficient and reliable operation. This service supports proper system function before home sales.

Beacon Home Services inspected the HVAC system in a commercial building in Nampa, ID. They confirmed the system works properly but requires annual maintenance and filter changes. They noted one unit was inaccessible due to a drop ceiling and recommended installing access for future maintenance.

Beacon Home Services provided a full HVAC service and system tune-up for a home in south Meridian, ID. They completed the service and delivered a comprehensive system report to the customer.

Beacon Home Services in Caldwell, ID repaired a heat pump and provided options to repair or replace a 10+ year-old unit. They assessed the system’s condition and completed necessary repairs to restore its function efficiently.

Beacon Home Services in Boise, ID performed air conditioning maintenance, including installing a MERV 13 air filter to improve indoor air quality by capturing dust and allergens. They inspected and cleaned the furnace and condenser coils, checked electrical components, and confirmed the system operates efficiently.

Beacon Home Services in Boise, ID performed routine HVAC maintenance, inspecting and testing an air conditioner and furnace system in a crawlspace. They replaced the air filter, cleaned return air grilles, rinsed the condenser coil, and checked electrical components. They also identified a refrigerant recharge needed for efficient cooling.

Beacon Home Services in Boise, Idaho inspected an old water heater and an HVAC unit over 20 years old. They provided three replacement options to the customer. The customer expressed interest in available financing plans.

Beacon Home Services replaced a corroded outdoor AC condenser and offered discounted installation of a new air conditioner and furnace. They previously replaced a water heater in Boise, Idaho.

Beacon Home Services in Boise, Idaho, turned off power and reclaimed 410a refrigerant. They disconnected the line set and power, then moved the condenser to the other side of the yard for landscaping work.

Beacon Home Services repaired an outdoor condenser contactor that failed, restoring proper cooling function in Boise, Idaho. The technician replaced the contactor on the outside unit to fix the cooling issue efficiently.

Beacon Home Services installed 25 feet of new piping for a condensation pump in Boise, Idaho. They supplied all parts and labor, provided a one-year warranty, and ensured the installation had no leaks and worked properly.

Beacon Home Services repaired an air-conditioning system in East Boise, Idaho. They identified a low-voltage short, replaced the faulty components, and restored the unit to full working condition.